ANSI/CAN/UL 330:2021 JOINT CNATION STANDARD FOR SAFETY Hose and Hose Assemblies forDispensing Flammable andCombustible Liquids

ANSI/CAN/UL 330:2021 JOINT CNATION STANDARD FOR SAFETY Hose and Hose Assemblies forDispensing Flammable andCombustible Liquids 1 Scope 1.1 This Standard sets forth minimum requirements for hose and hose assemblies，including vaporrecovery hose and assemblies, for use on dispensing devices for flammable and combustible liquids.Ahose assembly consists of flexible hose and fittings suitable for attachment to flammable and combustibleliquid dispensing equipment. 1.2Hose assemblies are intended for use: a) In the United States, in accordance with the Automotive and Marine Service Station Code ofNational Fire Protection Association,NFPA 30A; or b) In Canada, in accordance with the National Fire Code of Canada. 1.3 These requirements cover hose and hose assemblies (hose with couplings attached) in sizes up toand including 1-1/2 in (40 mm). 1.4 Hose for conveying liquid fuel is intended for use at a maximum working pressure of 50 psi (350kPa).Hose for conveying vapors of fuel is intended for use at a maximum working pressure of 0.5 psi(3.5kPa), including slight negative pressures from vapor assist systems. 1.5 These requirements cover hose and hose assemblies for use at temperatures down to -40°F(-40°C)or -65°F(-54°C)and up to +125°F(+52°C). NOTE: Products tested for performance at -40°F(-40℃) only are not marked for lowest operating temperature.Only products testedfor performance at-65°F(-54°C) are marked accordingly. 1.6These requirements also cover fuel hose assemblies designated as “low permeation ", intended foruse on dispensing devices for flammable and combustible liquids. 1.7These requirements do not cover hose or hose assemblies, intended for use in automotive vehiclesor in confined areas, except for locations inside the housings of dispensing devices complying with theStandard for Power-Operated Dispensing Devices for Petroleum Products, UL 87. 1.8 This Standard does not cover hose or hose assemblies for aircraft refueling service.2General 2.1Units of measurements