ISO 10320:2019 pdf free.Geosynthetics – Identification on site.
1 Scope
This document specifies the information accompanying geosynthetics to enable the user on site to identify the goods as being identical to the goods ordered. The positive identification, e.g. of unwrapped or rolled-out geosynthetics, is an important aim of this document.
The information specified does not replace a technical data sheet and cannot be used to verify the conformance of the product with the technical requirements.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
ISO 103 18-1, Geosynthetics — Part 1: Terms and definitions
ISO 10318-2, Geosynthetics — Part 2: Symbols and pictograms
3 Terms and definitions
For the purposes of this document, the following terms and definitions apply.
ISO and IEC maintain terminological databases for use in standardization at the following addresses:
— ISO Online browsing platform: available at https://www.iso.org/obp
— IEC Electropedia: available at http://vww.electropedia.org/
3.1 supplier person or organization from which a geosynthetic is purchased or otherwise obtained
Note I to entry: A supplier who is not the manufacturer is expected to ensure that the responsibilities of the manufacturer are fully met.
3.2 product name brand name name given to a particular product or complete range of products
3.3 product type descriptive number or code given to a particular material produced to a particular specification
3.4 unit identification information, e.g. number or other code usually given on each unit (e.g. roll) during or after production, which allows the original manufacturer to trace at a later stage the production details, including place and date of production
4 Identification
4.1 Unique identification on delivery
For the purposes of positively identifying the product at the time of delivery to the purchaser, geosynthetics shall be supplied with the following information affixed (e.g. label) to each unit:
a) manufacturer and/or supplier;
b) product name;
c) product type;
d) unit identification;
e) nominal gross mass of unit, in kilograms;
f) unit dimensions (of material, not of package);
— roll goods: length x width (both in metres),
— other goods: number of items (e.g. sheets or fabricated bags or tubes) x length x width (both in metres), or area covered by the product;
g) product classification using terms and symbols defined in Iso 10318-1 and ISO 10318-2;
h) main raw material type(s) performing the function (for each component);
I) colour identification unique to the product name and type (only for products identified by colour marking).
4.2 Product marking for identification on installation
There shall be a means of positively identifying the product at the time of its installation, even if it is no longer in the original packaging.
The product name and type shall be marked on the product, e.g. by printing or engraving. The marking shall be easily legible and sufficiently durable to permit identification at the time of installation, and shall be repeated at regular intervals in machine direction of not more than 5 m.
For products where printing or engraving is impractical, the marking shall be a printed ribbon affixed to the roll or a colour marking on the product. A printed ribbon shall show the product name and type. A colour marking shall correlate with the product name and type identified by the colour marking on the label.
Where the product is further processed prior to delivery, e.g. cut, such that product marking is impractical, each unit shall nevertheless have a unique identification.
ISO 10320 pdf download.